From the perspective of processing principle, the circuit board engraving machine is a combination of drilling and milling, and can handle multiple data input modes according to needs with ease. There are two types of computer engraving machines: laser engraving and mechanical engraving, both of which have high power and low power. Below are some methods to avoid rusting of carving machines.

The components of the circuit board engraving machine are prone to oxidation. Once oxidized and rusted, the accuracy of the engraving machine will be affected, and its useful life will naturally be shortened, which greatly increases the service life of the engraving machine. If you want to extend the service life of the engraving machine, you need to strengthen daily maintenance and protection to avoid rusting.

1. The surface of steel parts, such as ball screws, quenched steel raceways for rolling guides, and the surface of steel fasteners, should be wiped with a cloth or cotton dipped in butter every few days. Other parts should be regularly observed for weak rust. If rust occurs, it should be wiped off with a cloth dipped in engine oil and used as a key point for future rust prevention.

2. The surface of aluminum parts should also be wiped with a cloth dipped in butter every few days, or a layer of clear varnish can be sprayed. And often observe whether there are corrosion spots.

3. It is best to fill the cooling water tank with emulsified oil for rust prevention, and do not use clean water directly.

A thousand mile embankment was destroyed by an ant nest. If you want your carving machine to be durable and long-lasting, you cannot ignore daily rust prevention and maintenance!

Article sourced from Jiangmen single and double-sided circuit boardhttp://www.yonghongpcb.com